[si-za]

To connect your multi effects processor to your amp, you’ll need to follow these steps:

1. First, make sure your amp has an AUX input. This is usually a 1/8″ or RCA input located on the back or side of the amp. If it doesn’t have an AUX input, you may need to purchase a small mixer to connect the processor to the amp.

2. Connect the multi effects processor to the AUX input using a 1/8″ stereo cable. If your processor has RCA outputs, use an RCA-to-1/8″ stereo adapter.

3. Set the processor to output to the AUX mode. This is usually found in the setup or utility menu of the processor.

4. Turn on the processor and the amp.

5. On the processor, set the desired effect or tone.

6. On